help compiling quakeGX Wii

[Hazematman]

[Hazematman]

ok if anyone can't help me with that, does anyone know if there is a wii port of quake that is easier to compile?

[r00k]

[Hazematman]

[Hazematman]

[Hazematman]

after much research I found out that the quakeGX source didn't compile well, which may be due to the wrong makefile. So I was looking around and I found the q1rev engine, which apparently is not as good as quakeGX but at least the source code compiles well without any needed modification. You can get the source code here : .
also the project that comes with the source code is a msvc 2010 project so your might need to do some converter or just make a new project the compiles the code. On that note could someone else try to compile and run the gl version of q1rev and run it on their wii becuase when I ran the gl version on my wii all the textures were white, it ran really slow and none of the game menus worked.

[r00k]

Most of these wii ports are wrappers of openGL to GX api. So a lot of the internal workings are not as user friendly as one might assume. The only usefulness of these ports would best be to use quakeC mods on the wii. But from an engine standpoint it's a lot of work. IMHO Quake plays best using mouse+keyboard not a remote+nunchuck, so most mods lose functionality...

[Baker]

You might consider Bigfoot's FodQuake, a Quakeworld client port.

http://www.quakeworld.nu/forum/viewtopic.php?id=4167

[Hazematman]

Fodquake looks like it could be good, but I can't find the version of it that works with wii.

[Baker]

[r00k]

[Hazematman]

[Baker]

[r00k]

[Hazematman]