Sushi's wqpro problem

[Baker]

Hey man, your Easily fixed gfx.wad,etc. stickied post links to the main page....i was gonna look b/c i had some problems

1. Couldnt'f find gfx.wad
2. Bad Surface Extent

Also, I was curious...if u knew why WQPRO only gives me 60fps at 640x480....but when i drop it down to the minimal res (i think 430x320 or something) I am able to get around 500 fps?

Then in GLpro i can get 800-900 easily if i maxfps it at 900.

DOesn't make sense....and i love wqpro!

This is on my new pc:
Windows 7 ultimate 64bit, duo core 3.0ghz, 4gig ram, HD 4670 vid card

Adding -dibonly to a WinQuake command line or wqpro command line will increase your maximum fps to beyond the vertical sync of your monitor.

An OpenGL engine is going to get far more frames per second due to hardware acceleration than the software renderer versions (wqpro, winquake, etc) especially at higher resolutions [except if your graphics card can barely run glquake, obviously].